Toshiba 30HF85 User Manual - Page 16

Using the remote control Preparing the remote control for use With the remote control, you can operate your TV, most cable TV converters/satellite receivers, VCR and DVD player models together, even if they are different brands. If you will be using your TV with a Toshiba satellite receiver, VCR or DVD player, your remote control is already programmed and ready to use. If you own different brands of cable TV converters/satellite receivers, VCRs and/or DVD players, you first have to program your remote control. (See "Programming the remote control for use with a cable TV converter/satellite receiver, VCR or DVD player" on page 17.) Installing the remote control batteries To install the batteries: 1. Open the battery cover on the back of the remote control. Note: The TV remote control may not operate your VCR, DVD player, or cable TV converter. Refer to the owner's manual supplied with the applicable equipment to see which features may be available. Additionally, the remote control for this TV may not support certain features available on the original remote controls for such additional equipment, in which case, it is suggested that you use the original remote control for the applicable device. Caution: • Never throw batteries into a fire. 2. Install two "AAA" size batteries. Match the + and - signs on the batteries to the signs on the battery compartment. 3. Close the battery cover on the remote control until the lock snaps. Notes: • Be sure to use "AAA" size batteries. • Dispose of batteries in a designated disposal area. • Attention should be drawn to the environ- mental aspects of battery disposal. • Do not mix different battery types or combine used batteries with new ones. • If the remote control does not operate correctly, or if the operating range becomes reduced, replace both batteries with new ones. • If the batteries are dead or if you will not be using the remote control for a long time, remove the batteries to prevent battery acid from leaking into the battery compartment. Using the remote control to operate your other devices To control a cable TV converter/satellite Power Input (TV) receiver: Mute (TV) Program the remote Channel Numbers control to recognize the brand of your cable TV CH RTN (Channel Return) converter/satellite receiver Channel 3 4 (see "Programming the CBL/SAT remote control to operate Volume +/- (TV) your other devices" on Pic Size (TV) page 17.) The buttons shown at right will control the cable TV converter/ satellite receiver. Press "CBL/SAT" first. TV/VCR To control a VCR: Program the remote control to recognize the brand of your VCR Input (TV) Power Channel Numbers (see "Programming the CH RTN remote control to (Channel Return) operate your other VCR devices" on page 17.) Channel 3 4 The buttons shown at Volume +/- (TV) right will then control Pic Size (TV) the VCR. Press "VCR" first. VCR controls Using the Remote Control J3S40121B(E)_P16-23 16 16 24/02/2005, 6:06 PM