Toshiba TDP-TW420U Owners Manual - Page 18

Using handy features (Continued) How to set password (from [Off] to [On]) 1 Select [Password] in the Default setting 2 menu and press the or button. 2 Select [Password setting] next, and press the or button. 3 Select [On]. 4 Select [OK] and press the button. The password entry screen is displayed. 5 Enter the password using numeric keys of the remote control. 6 The password setting will be set as [On]. How to operate when password is [On] 1 Turn on the power. 2 The lamp lights and the password entry screen appears. 3 Enter the password using numeric keys of the remote control. If the entered password is correct, the start-up screen appears and the projector goes into normal operation. If the password is wrong, a message appears to prompt you to re-enter the password, and again the password entry screen is displayed. If you enter a wrong password for more than 5 times, the projector will automatically power off and enter standby mode. Note • When the password setting is [On], the password function will be enabled only when the projector is restarted after the main power switch has been turned off. The password that you set will not be enabled when restarting from standby mode without turning off the main power switch. How to set password (from [On] to [Off]) 1 Select [Password] in the Default setting 2 menu and press the or button. The password entry screen is displayed. 2 Enter the password using numeric keys of the remote control. 3 Select [Password setting] next, and press the or button. 4 Select [OFF]. 5 Select [OK] and press the button. 34 Using the menus 1 You can call up on-screen menus, and conduct a number of adjustments and settings using the MENU button p.16 on the control panel (main unit side) and remote control.  Setup using the Setting display The menu shown below is for operation instructions purposes and might differ from the actual display. 1. Press the MENU button Display the Setting display menu. 2. Select a Category Select a category by using . There are following 6 categories: Image adjustment menu p.36 Position adjustment menu p.37 Display setting menu p.38 Default setting 1 menu p.41 Displays the current adjustments and settings of selected category. Item shown with gray cannot be adjusted with the current input source. Default setting 2 menu p.42 Status display menu p.43 3. Adjustments & Settings Press or to open the menu. Item Adjustment/Setting Value These marks signify the items can be adjusted/set by using . These marks signify that there are options. Press or to display a list of options. These marks signify that there are setting screens. Press or to display a list of setting screens. These marks signify the items can be selected from the list by using . After an item is selected, apply it by pressing . * When no item is changed, press . Toggle items with . Select items with and press . Fix selection with . • The figure shows displays given for operation instructions purposes. As the display may differ depending on the item, refer to the following applicable pages for the menu item you desire. • To return to previous item, press the RETURN button. • When Network or USB memory input is selected, pressing the MENU button twice displays the Setting display (2) menu. 4. End Press the MENU button once more. (The menu will disappear automatically after 30 seconds, if no operation is conducted.) 35 Operations