Toshiba TDP-TW420U Owners Manual - Page 51
CONTROL terminal, Pin assignment, Interface format, Main Commands
![]() |
UPC - 883974104604
View all Toshiba TDP-TW420U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Specifications (Continued) CONTROL terminal Pin assignment D sub 9 pin connector Pin No. Signal Name Description 1 DCD Data carrier detect 2 TXD Sending data 3 RXD Receiving data 4 DTR Data terminal ready 5 GND Signal ground 6 DSR Data set ready 7 RTS Request to send 8 CTS Consent to send 9 DC 5 V 5 VDC OUTPUT Interface format 1. Communication method RS-232C, 9600 bps, No Parity, Data Length: 8 bits; Stop Bit Length: 1 bit 2. Communication format STX (02 h) Command (3 Byte) ETX (03 h) Only 1 command valid per communication. 3. Data format For input commands, only ASCII-compliant all- uppercase alphanumeric characters supported. 4. Replies Acknowledge ACK (06 h) CR(0 Dh) Data ... Normally ended ACK (06 h) ESC(1 Bh) ... Aborted No acknowledge NAK (15 h) If commands are to be sent consecutively, wait for the response from the projector before sending the next command. Main Commands Item Power on Power off Icon display on Icon display off Auto setting (RGB input) Status display on Status display off Command PON POF MO0 MO1 PAT DON DOF Note • Contact your dealer for control cable and other commands. 100
![](/manual_guide/products/toshiba-tdptw420u-owners-manual-7fe08f5/51.png)