Tripp Lite 5P3000 Eaton 5P1500RT 5P2200RT 5P2200 5P3000RT 5P3000 UPS Installat - Page 11

ENGLISH 2. Presentation 2.5 Display functions Press the Enter ( ) button to activate the menu options. Use the two middle buttons ( and ) to scroll through the menu structure. Press the Enter ( ) button to select an option. Press the button to cancel or return to the previous menu. Menu map for Display Functions. Main menu Measurements Control Settings Fault log Identification Submenu Display information or Menu function Load W VA / Load A pf / Output V Hz / Input V Hz / Battery V min / Efficiency / Power usage Load Segments Group 1: ON / OFF Group 2: ON / OFF These commands overrule user settings for load segments. Start battery test Starts a manual battery test Reset fault state Clears active fault (UPS restart required) Restore factory settings Returns all settings to original values Reset power usage Clears power usage measurements Local settings Sets product general parameters Input / output settings Sets Input and output parameters ON / OFF settings Sets ON / OFF conditions Battery settings Sets battery configuration Displays event log or alarms UPS Type / Part Number / Serial Number / Firmware release / Com card address 2.6 User settings The following table displays the options that can be changed by the user. Local settings In/Out settings Description Language LCD settings Audible alarm Output voltage Input thresholds Sensitivity Load segments Auto start delay Available settings [English] [French] [German] [Italian] [Portuguese] [Spanish] [Russian] Menus, status, notices and alarms, UPS fault, Event Log data and settings are in all supported languages. Authorizes to modify LCD screen brightness and contrast to be adapted to room light conditions. [Yes] [No] Authorizes to enable or disable the buzzer if an alarm occurs. [100 V] [120 V] [125 V] [Normal mode] [Extended mode] Extended mode authorizes lower input voltage (70 V) without transferring to battery. This can be used if the load can withstand low voltage supply. [High] [Low] High: for sensitive equipment, UPS will easily transfer to battery when utility conditions are becoming bad. Low: for equipment that can withstand bad utility conditions, in that case, the UPS will not transfer to battery. [No Delay] [1 s] [2 s]...[65354 s] The equipment are powered on with the specified delay relative to the primary group. Default settings English User selectable when UPS is powered for the first time. Yes User selectable when UPS is powered for the first time. Normal mode High Group 1: 3 s Group 2: 6 s 614-03898-00_EN Page 11