Tripp Lite 5P3000 Eaton 5P1500RT 5P2200RT 5P2200 5P3000RT 5P3000 UPS Installat - Page 18

3. Installation HotSwap MBP module operation ByPass UPS OUT Normal UPS ON OK to switch 29 30 31 The HotSwap MBP module has a rotary switch 31 with two positions: Normal the load is supplied by the UPS, LED 29 is on. Bypass the load is supplied directly by the AC-power source. LED 30 is on. UPS start-up with the HotSwap MBP module 1. Check that the UPS is correctly connected to the HotSwap MBP module. 2. Set switch 31 to Normal position. 3. Start the UPS by pressing the ON/OFF button on the UPS control panel. The load is supplied by the UPS. LED 29 "UPS ON - OK to switch" on the HotSwap MBP module goes ON. HotSwap MBP module test 1. Set switch 31 to Bypass position and check that the load is still supplied. 2. Set switch 31 back to Normal position. 3.8 UPS connection without a FlexPDU or HotSwap MBP module Check that the indications on the name plate located on the back of the UPS correspond to the AC-power source and the true electrical consumption of the total load. 1. 5P: connect the UPS input plug 10 to the AC-power source. 98 10 2. Connect the loads to the UPS. It is preferable to connect the critical loads to the 'Primary' outlet group shown as 9 and the non-critical loads to either the Group 1 or Group 2 outlets shown as 8 . Group 1 and Group 2 outlets can be programmed to shed loads as desired. For the 5P 3000 models, connect any high-power device to the 30 A outlet 7 . 3. To program shutdown of outlets 8 during operation on battery power to optimize the available backup time, please check the in/out settings. Note: The UPS charges the battery as soon as it is connected to the AC-power source, even if button is not pressed. Once the UPS is connected to the AC-power source, eight hours of charging is required before the battery can supply the rated backup time. Page 18 614-03898-00_EN