Troy-Bilt CSV 060 Operation Manual - Page 9
Adjustments, Set-Up - will not start
View all Troy-Bilt CSV 060 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Bag 1. Grasp bag handle with one hand and slide locking rod on mounting bracket with other hand toward engine. Use the end of mounting bracket as leverage when sliding the locking rod. See Fig. 3-6. 3 Adjustments Nozzle Height The nozzle can be adjusted to any six positions, ranging from 5/8" to 4 1/8" ground clearance. The nozzle height has to be adjusted according to chipper shredder conditions. 1. Depress nozzle height adjustment lever towards wheel. See Fig. 3-7. 2 2 1 4 Figure 3-6 3 1 2. Slip bag over the rim of the discharge opening and release locking rod to secure bag in place. Figure 3-7 3. Snap bag clip to the top of the lower handle. 4. Place the lower straps on the bag over the top of lower handle, hooking them on the studs. See Fig. 3-6. NOTE: The bag/chute switch button attached to the mounting bracket must be fully depressed by the tip of 2. Move the height adjustment lever forward or backward to adjust the nozzle upwards or downwards. Make sure both levers are in the same position. 3. Release lever towards deck. See Fig. 3-7. front tab on bag handle when securing the bag or engine NOTE: In general, raise the nozzle height to vacuum a will not start. thick layer of leaves. Lower the nozzle height for smoother surfaces. Set-Up Gas and Oil Fill-Up Refer to the separate engine owner's manual for additional engine information. 1. Add oil provided before starting unit for the first time out of the box. 2. Service the engine with gasoline as instructed in the separate engine owner's manual. WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel the machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes and other sources of ignition. WARNING: Never fill fuel tank indoors with engine running or until the engine has been allowed to cool for at least two minutes after running. Section 3 - Assembly & Set-Up 9