Via VB8001-16 User Manual - Page 24

Connectors

Get Via VB8001-16 - VIA Motherboard - Mini ITX PDF manuals and user guides View all Via VB8001-16 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Chapter 2 Connectors The VIA EPIA-V Mini-ITX Mainboard provides the following connectors: Hard Disk Connectors: IDE1 The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100 controller that provides PIO mode 0~4, Bus Master, and Ultra DMA 33/66/ 100 functions. You can connect up to two hard disk drives, CD-ROM, LS120 and other devices. These connectors utilize the provided IDE hard disk cable. IDE 1 IDE1 (Primary IDE Connector) The first hard drive should always be connected to IDE1. IDE1 can connect a Master and a Slave drive. TIP: If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper. Refer to the hard disk documentation supplied by hard disk vendors for jumper setting instructions. 2-10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
Chapter 2
2-10
IDE 1
Connectors
The VIA EPIA-V Mini-ITX Mainboard provides the following connectors:
Hard Disk Connectors: IDE1
The mainboard has a 32-bit Enhanced PCI IDE and Ultra DMA 33/66/100
controller that provides PIO mode 0~4, Bus Master, and Ultra DMA 33/66/
100 functions. You can connect up to two hard disk drives, CD-ROM, LS-
120 and other devices. These connectors utilize the provided IDE hard disk
cable.
TIP:
If you install two hard disks on cable, you must
configure the second drive to Slave mode by setting its jumper.
Refer to the hard disk documentation supplied by hard disk
vendors for jumper setting instructions.
IDE1
(Primary IDE Connector)
The first hard drive should always be connected to IDE1. IDE1 can
connect a Master and a Slave drive.