Viper 350 Plus Owner Manual - Page 15

Disarming without a transmitter - remote

Get Viper 350 Plus PDF manuals and user guides View all Viper 350 Plus manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

➢ Disarming without a transmitter This feature allows you to disarm the security sys­tem without the remote trans­mit­ter should it be lost, dam­aged, or disabled. In order to dis­arm the system with­out a remote transmitter, you must have the ve­hi­cle's ig­ni­tion key and know where the Valet switch is located. Be sure to check with the installer for the location and the number of presses of the Valet switch required to disarm the system. To disarm the security system, turn the ignition to the ON position. Press the Valet switch the preset number of times (one to five times) within 15 seconds. After 5 seconds, the syst­em will now disarm. If the system does not disarm, you may have waited too long; turn the ignition off and on and try again. Location of Valet switch Number of Presses Important! The unit can be programmed to respond to one to five presses of the Valet switch for the disarm function. Be sure to check with the installer for the desired programming. © 2008 Directed Electronics - All rights reserved. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
13
© 2008 Directed Electronics - All rights reserved.
➢
Disarming without a transmitter
This feature allows you to disarm the security system without the
remote transmitter should it be lost, damaged, or disabled. In order
to disarm the system without a remote transmitter, you must have the
vehicle’s ignition key and know where the Valet switch is located.
Be sure to check with the installer for the location and the number of
presses of the Valet switch required to disarm the system.
To disarm the security system,
turn the ignition to the ON po-
sition. Press the Valet switch
the preset number of times
(one to ±ve times) within 15
seconds.
After 5 seconds, the system will now disarm. If the system does
not disarm, you may have waited too long; turn the ignition off
and on and try again.
Location of Valet switch_________________________________
Number of Presses______________________________________
Important!
The unit can be programmed to respond to one to ±ve
presses of the Valet switch for the disarm function. Be sure to check
with the installer for the desired programming.