Viper 350 Plus Owner Manual - Page 24
Rapid resume logic, Power saver mode
View all Viper 350 Plus manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Rapid resume logic This Directed system will store its current state to non-volatile memory. If power is lost and then reconnected, the system will recall the stored state from memory. This means if the unit is in Valet Mode and the battery is disc onn ected for any reason, such as servicing the car, when the battery is reconnecte d the unit will still be in Valet Mode. This applies to all states of the system including arm, disarm, VRS®, and Valet Mode. Power saver mode Your system will automatically enter Power Saver Mode while armed or in Valet Mode, after a period of time in which no operation has been performed. This lowers the current draw to the vehicle's battery. Power Saver Mode takes over under the following conditions: • Power Saver when the system is armed: After the system has been armed for 24 hours, the LED will flash at half its normal rate, decreasing the system's current draw. • Power Saver in Valet Mode: When the system enters Valet Mode the LED illuminates steadily. If the vehicle is not used (ignition is not turned on) for a period of one hour while the system is in Valet Mode, the LED will shut off. If the system remains in Valet Mode, the LED will come back on the next time the ignition is turned on and then back off. 22 © 2008 Directed Electronics- All rights reserved.