Viper 350 Plus Owner Manual - Page 18

tant to remember that the NPC programming can cause zones - reset

Page 18 highlights

If the bypassed sensor tries to trigger the system while it is being bypassed, the 60-minute bypass period will start over. This ensures that a sensor that continually triggers will remain bypassed. Doors are covered by NPC differently; if the alarm is triggered by an open door for three full cycles, the doors will be bypassed until the trigger ceases. Arming and disarming the system does not reset this function!. The only ways to reset a bypassed zone are for it to not trigger for 60 minutes, or to turn on the ignition. If testing your system, it is important to remember that the NPC programming can cause zones to be bypassed and appear to stop working. If five chirps are heard when disarming, NPC has been engaged. If you wish to clear the NPC memory, turn the ignition key on. NPC is programmable. See Programming Options section of this guide. 16 © 2008 Directed Electronics- All rights reserved.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

16
© 2008 Directed Electronics- All rights reserved.
If the bypassed sensor tries to trigger the system while it is being
bypassed, the 60-minute bypass period will start over. This en-
sures that a sensor that continually triggers will remain bypassed.
Doors are covered by NPC differently; if the alarm is triggered
by an open door for three full cycles, the doors will be bypassed
until the trigger ceases.
Arming and disarming the system does not reset this function!. The
only ways to reset a bypassed zone are for it to not trigger for 60
minutes, or to turn on the ignition. If testing your system, it is impor-
tant to remember that the NPC programming can cause zones to
be bypassed and appear to stop working. If ±ve chirps are heard
when disarming, NPC has been engaged. If you wish to clear the
NPC memory, turn the ignition key on.
NPC is programmable. See Programming Options section of this
guide.