Viper 350 Plus Owner Manual - Page 21
Table of zones, Interpreting zone diagnostics
View all Viper 350 Plus manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
➢ Table of zones The zone number is the number of LED flashes used by the system to identify that input. The standard input assignments are listed below, along with spaces to write in any optional sensors or switches you have had installed. Zone - Number of LED Flashes Description Dealer-Installed Options 1 Instant trigger - often used for hood/trunk pinswitches 2 Instant trigger - a heavier impact detected by the shock sensor 3 Door switch trigger 4 Instant trigger - for optional sensors 5 Ignition trigger ➢ Interpreting zone diagnostics Warn Away responses are not reported by arming or disarming diagnostics. If you receive a Bypass notification when arming or a Tamper Alert notification when disarming, look at the LED. Active or triggered zones will be indicated by a pattern of blinks by the LED. Example: If zone 3 was active or triggered, the LED will blink three times with a two-second pause. Then it will blink three times again, and repeat until the ignition is turned on. Your system stores the last two triggered zones in memory. If your system has been triggered but the LED has been reset by turning on the ignition, your dealer can still recall the last two zones that were triggered. Contact your dealer for details © 2008 Directed Electronics - All rights reserved. 19