Weider Pro 435 Bench Uk Manual - Page 10
Attach the Curl Pad 27 to the Curl Post 26
View all Weider Pro 435 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
13. Attach the Curl Pad (27) to the Curl Post (26) 13 with two M6 x 16mm Bolts (15). 27 14. Press a 50mm Square Inner Cap (54) into the top 14 of the Lat Tower (47). Press Carriage Bushings (49) into the top and bottom of the Weight Carriage (48). Press two 25.4mm Round Inner Caps (23) into the ends of the weight tube. Insert an M10 x 20mm Bolt (50) into the bracket from the direction shown. Slide the Weight Carriage (48) onto the bottom of the Lat Tower (47) as shown. Press a Bushing (28) into the top of the Carriage Stop (52). Attach the Carriage Stop to the indicated hole in the Lat Tower (47) with an M8 x 70mm Bolt (67) and an M8 Nylon Locknut (13). 15. Find the Cable (58); note that it has a ball on one 15 end and a loop on the other. Route the loop end of the Cable through the slot in the Lat Tower (47) and over a Pulley (55) as shown. Attach the Pulley inside the slot with an M10 x 65mm Bolt (40), two M10 Washers (24), two Wide Spacers (44), and an M10 Nylon Locknut (19). Slide the loop on the Cable (58) onto the M10 x 20mm Bolt (50) and secure it with an M10 Nylon Locknut (19). 15 15 26 54 Lat Bar Rest 47 Hole Bracket 23 Weight Tube 49 13 49 50 48 23 28 67 52 19 44 24 55 Slot 44 58 24 40 47 50 19 16. Make sure that all the bolts and nylon locknuts are properly tightened before you use the weight bench. The use of all remaining parts will be explained in ADJUSTMENTS, starting on the following page. 10