Weider Pro 435 Bench Uk Manual - Page 9

9. Orient the Seat (11) with the wide end on the side shown. Attach the Seat to the Bench Frame (2) with four M6 x 16mm Bolts (15). 9 11 Wide End 10. Insert 19mm Round Inner Caps (9) into both ends of the three Pad Tubes (10). Slide the Pad Tubes 10 22 into the holes in the Leg Lever (4) and the Front Leg (8). Slide two Foam Pads (22) onto each Pad 4 Tube. 22 2 15 15 8 9 10 9 11. Slide a Bushing (28) onto the bottom of each Upright (1). Be sure the tab is on the indicated side of the Bushing. Press a 60mm x 50mm Bushing (31) into the bottom of each Upright and secure it with two M4 x 8mm Screws (34). Attach the Right Barbell Hook (56) to an Upright (1) with a Bright M8 Washer (63) and a Bright M8 Nylon Locknut (62). Attach the Left Barbell Hook (61) to the other side of the other Upright in the same manner. Orient the two Uprights as shown. 12. Press the tabs on the Bushing (28) into the slots in the left Upright (1). Slide the Upright and the Bushing into the left Upright Base (7), so that the tabs snap into the slots in the Upright Base. Note: Be careful not to pinch your fingers Align one of the adjustment holes in the Upright (1) with the hole in the Upright Base (7). Tighten an M10 x 62mm Adjustment Knob (30) into the holes. Attach the right Upright (1) to the right Upright Base (7) in the same manner. Note: Always set both Uprights at the same height. WARNING: Do not insert the M10 x 62mm Adjustment Knob (30) through the slot in the Upright (1). 11 62 63 1 28 34 31 12 1 28 7 9 22 10 9 56 61 1 Tab 34 Adjustment Hole 1 28 Tab Slot 7 30 9