Weider Pro 435 Bench Uk Manual - Page 6
Assembly
View all Weider Pro 435 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY Make Things Easier for Yourself This manual is designed to ensure that the weight bench can be assembled successfully by anyone. Most people find that by setting aside plenty of time, assembly will go smoothly. Before beginning assembly, carefully read the following information and instructions: • Assembly requires two persons. • For help identifying small parts, use the PART IDENTIFICATION CHART on page 5. • Tighten all parts as you assemble them, unless instructed to do otherwise. • As you assemble the weight bench, make sure all parts are oriented as shown in the drawings. • Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. The following tools (not included) are required for assembly: • two adjustable spanners • one rubber mallet • one standard screwdriver • one Phillips screwdriver • lubricant, such as grease or petroleum jelly, and soapy water. Assembly will be more convenient if you have a socket set, a set of open-end or closed-end spanners, or a set of ratchet spanners. 1. Before assembling the weight bench, make sure that you have read and understand the information in the box above. Press four 60mm Square Inner Caps (65) into the ends of the Right and Left Stabiliser (45, 46). Attach an Upright Base (7) to the Right Stabiliser (45) with four M10 x 80mm Bolts (35), two Joint Plates (20), and four M10 Nylon Locknuts (19). Do not tighten the Nylon Locknuts yet. Note: The welded nut on the Upright Base must be on the side shown. Attach an Upright Base (7) to the Left Stabiliser (46) in the same manner. 1 Welded Nut Welded Nut 7 65 19 20 45 20 35 65 35 20 7 65 65 46 20 19 6