Weider Pro 550 Bench Uk Manual - Page 9
Locknut; the Seat Frame and the Backrest
View all Weider Pro 550 Bench manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
8. Attach the tether on the Seat Pin (40) to the 8 Seat Fame (10) with an M4 x 16mm Self-tap- ping Screw (57). Orient the Seat (21) as shown. Attach the Seat to the Seat Frame (10) with four M6 x 16mm Screws (41). 21 57 40 Wide End 10 9. Orient the two Backrest Frames (17) with the holes in the position shown and orient the Backrest (22) with the wide end in the position shown. Attach the Backrest to the two Backrest Frames with four M6 x 40mm Screws (48) and four M6 Washers (54). Do not tighten the Screws yet. 9 Wide End 41 41 22 10. Note: For clarity, the Seat (21, see step 8) is not shown in this drawing. Apply grease to an M10 x 145mm Bolt (53). Attach the Seat Frame (10) and the Backrest Frames (17) to the Seat Carriage (42) with the Bolt, two M10 Washers (43), and an M10 Nylon Locknut (58). Do not overtighten the Locknut; the Seat Frame and the Backrest Frames must pivot easily. Insert the Seat Pin (40) through the Seat Frame (10) and into the tube on the Seat Carriage (42). Tighten the four M6 x 40mm Screws (48) used in step 9. 17 Holes 54 54 17 48 54 54 48 10 58 43 40 10 43 42 17 Grease 53 Tube 9