Weider Pro 9725 English Manual - Page 7
identification
View all Weider Pro 9725 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
RAME ASSEMBLY 8. Attach the upper ends of the Weight Guides 8 (62) to the Top Frame (55) with the 5/16" x 6" Bolt (60), two 1/2" x 3/4" Spacers (61), and a 5/16" Nylon Locknut (3). Tighten all Nylon Locknuts used in steps 2 through 8. 3\ 55 , 61 . 62 . 60 . . ion Press a 1" x 7/8" Plastic Bushing (75) onto each welded spacer on the Press Frame (17). Slide the Press Frame into place on the Front Base (4). Note: This will be a tight fit. The Plastic Bushings should fit onto each end of the indicated tube in the Base. Be sure that the indicated holes are on the side shown. Lubricate the 3/8" x 8" Bolt (59). Attach the Press Frame (17) to the Front Base (4) with the 3/8" x 8" Bolt and a 3/8" Nylon Locknut (21). 10. Press a 1 3/4" Square Inner Cap (44) into the top of a Press Arm (46). Press a i" Round Inner Cap (49) into the side of the Press Arm. Attach the Press Arm to one side of the Press Frame (17) with two 5/16" x 2 1/2" Bolts (22) and two 5/16" Nylon Locknuts (3). Assemble the other Press Arm (46) in the same manner. 11. Identify the Right Arm (48) and the Left Arm (47). Note the position of the welded bracket on each Arm. Arm identification is very important for step 12. Attach a "V"-Pulley (6) and a Long Cable Trap (50) to the Right Arm (48) with a 3/8" x 2 1/2" Bolt (7) and a 3/8" Nylon Locknut (21). Attach a "V"-Pulley (6) and a Long Cable Trap (50) to the Left Arm (47) with a 3/8" x 2 1/2" Bolt (7) and a 3/8" Nylon Locknut (21). 9 ,....) . . . 4 Tube 10 I IIIV . . 0 4 . 17 Holes must be on this side Lubricate 59 . , 21 Welded Spacers 75 44 -Q, 0-49 44 49 . 22 46 . .. - a 3 17 11 r7 A(.91-50 50.,--,tr_ i 6 -:- Welded Brackets 21 46 47 48 7