Whirlpool RBD305PRS Use and Care Manual - Page 6

All Tones All of the above tones are preset on, but can be turned off. To Turn Off/On: Press and hold STOP TIME for 5 seconds, and a tone will sound. On double ovens only, "Snd OFF" and "Snd On" will remain in the display. To remove, press UPPER OFF/ CANCEL, LOWER OFF/CANCEL, or OFF/CANCEL. Reminder Tones The Timer and Timed Cooking reminder tones are preset on, but can be turned off. Reminder tones do not include end-of-cycle tones. If "All Tones" have been turned off, the reminder tones cannot be turned on independently. Timer To Turn Tones Off/On: Press and hold TIMER SET until a tone sounds. The display will show "TIMER" and "NA9 On" or "TIMER" and "NA90FE" To remove from the display, press UPPER OFF/CANCEL, LOWER OFF/CANCEL or OFF/CANCEL. Repeat to turn back on. Timed Cooking To Turn Tones Off/On: Press and hold COOK TIME until a tone sounds. The display will show "COOK TIME" and "NA9 OFF" or "COOK TIME" and "NA9 On" to indicate the status of the cook time tones. To remove from the display, press UPPER OFF/ CANCEL, LOWER OFF/CANCEL or OFF/CANCEL. Repeat to turn back on. The temperature is preset at Fahrenheit, but can be changed to Celsius. To Change: Touch and hold CUSTOM BROIL for 5 seconds. A tone will sound, and "C" will appear on the display. Repeat to change back to Fahrenheit. To remove, touch UPPER OFF/ CANCEL, LOWER OFF/CANCEL or OFF/CANCEL The Timer can be set in hours and minutes and counts down the set time. The Timer does not start or stop the oven. To Set: 1. Press TIMER SET. If no action is taken after 4 minutes, the electronic oven display will return to the time of day mode. 2. Press the HOUR or MIN "+" or "-" keypads to set length of time. 3. Press TIMER SET or START. If not pressed within 4 minutes, the display will return to the time of day mode and the programmed function will be canceled. When the set time ends, if enabled, end-of-cycle tones will sound, then reminder tones will sound every minute. 4= Press TIMER OFF anytime to cancel the Timer and/or stop reminder tones. Remember, do not press the Off/Cancel pads because the respective oven will turn off. The time can be reset during the countdown by repeating the above steps. The Control Lock shuts down the control panel pads to prevent unintended use of the ovens. When the control is locked, only the CLOCK, TIMER SET, TIMER OFF and OVEN LIGHT pads will function. The Control Lock is preset unlocked, but can be locked. To Lock/Unlock Control: Before locking, make sure the ovens, Timer and Timed Cooking are off. Press and hold START until a single tone sounds, and "Loc," a picture of a lock and "START?" will appear on the oven display, about 5 seconds. Repeat to unlock and remove "Loc" from display. IMPORTANT: Do not use a thermometer to measure oven temperature because opening the oven door and element or burner cycling may give incorrect readings. The oven provides accurate temperatures; however, it may cook faster or slower than your previous oven, so the temperature calibration can be adjusted. It can be changed in Fahrenheit or Celsius. A minus sign means the oven will be cooler by the displayed amount. The absence of a minus sign means the oven will be warmer by the displayed amount. Use the following chart as a guide. ADJUSTMENT °F (ADJUSTMENT °C) COOKS FOOD 10°F (5°C) ...a little more 20°F (10°C) ...moderately more 30°F (15°C) ...much more -10°F (-5°C) ...a little less -20°F (-10°C) ...moderately less -30°F (-15°C) ...much less To Adjust Oven Temperature Calibration: 1. Press and hold BAKE until the oven display shows the current calibration, for example, "0 ° CAL." 2. On double oven models only, press UPPER OVEN or LOWER OVEN. 3. Press the TEMP "+" or "-" keypads to increase or to decrease the temperature in 10° F (5°C) amounts. The adjustment can be set between 30°F (15 ° C) and -30 °F (-15° C). 4. Press START.