Whirlpool WGD92HEF Instruction Sheet - Page 7
Screws, Lower, Protective, Shield, Bulkhead, Clips - Main, Harness, Bracket, Plastic, Side Panel,
View all Whirlpool WGD92HEF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
14. Remove bulkhead assembly by first removing four (4) screws securing the bulkhead assembly to cabinet. Slightly lift up on bulkhead assembly and at the same time pulling away from drum working rollers off drum. See Figure 14. NOTE: During removal of bulkhead, take special notice of the Lower Protective Shield to ensure proper orientation during reassembly. 16. To gain further access to the burner assembly the drum will need to be removed. Before removing drum from dryer the CCU and bracket assembly must be secured in position to side panel using the plastic hook attached to the main harness. This will allow the CCU assembly to hang in place rather than dropping down when the drum is removed. See Figure 16. NOTE: Only on models with the CCU Bracket located on the right side of the unit. HOOK - PLASTIC SIDE PANEL (4) SCREWS LOWER PROTECTIVE SHIELD FIGURE 14 15. Swing bulkhead assembly to side and remove two (2) harness clips to disconnect harness from bulkhead. See Figure 15. NOTE: Only on models with the CCU Bracket located on the right side of the unit. CCU BRACKET BULKHEAD (2) CLIPS - MAIN HARNESS CCU BRACKET FIGURE 16 17. Remove drum from dryer by first reaching into dryer just under the drum, to back side of drive motor. Grasp idler pulley and lift up to relieve tension from belt and remove belt from motor pulley and idler pulley. Refer to Figure 17 for belt removal and reassembly. IDLER PULLEY DRYER DRUM DRUM DRIVE BELT MOTOR FIGURE 15 FIGURE 17 7