Whirlpool WRFF5333P Owners Manual - Page 29

Bisphenol A 2000 ± 20% 300 ng/L >99.1% 99.1% Estrone 140 ± 20% 20 ng/L >96.6% 96.4% Nonylphenol 1400 ± 20% 200 ng/L >96.7% 96.6% Ibuprofen 400 ± 20% 60 ng/L >95.5% 95.3% Naproxen 140 ± 20% 20 ng/L >96.8% 96.7% Phenytoin 200 ± 20% 30 ng/L >95.5% 95.5% Turbidity 11 NTU ± 10% 0.5 NTU 98.8% 98.2% Chlorobenzene 2.0 ± 10% 0.1 mg/ L >99.9% 99.9% Test Parameters: pH = 7.5 ± 0.5 unless otherwise noted. Flow = 0.70 gpm (2.65 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (20°C to 22°C). Rated service capacity = 200 gallons (757 liters) with PID, 100 gallons (379 liters) without PID. The compounds certified under NSF 401 have been deemed as "emerging compounds/incidental contaminants." Emerging compounds/ incidental contaminants compounds that have been detected in drinking water supplies at trace levels. While occurring at only trace levels, these compounds can affect the public acceptance/ perception of drinking water quality. � For installation, operation, and maintenance instructions please refer to the Owners Manual. � It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. Property damage can occur if all instructions are not followed. � The disposable cartridge must be changed at least every 6 months. � The product is for cold water use only. � The water system must be installed in compliance with state and local laws and regulations. � Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. EPA Est. No. 69625-CT-001 � Use replacement filter Part # EDR4RXD1/EDR4RXD1B. 2018 � Refer to the "Warranty" section (in the User Instructions or User suggested retail price of $49.99 U.S.A./$49.95 Canada. Prices Guide) for the Manufacturer's limited warranty, name and are subject to change without notice. telephone number. � The filter monitor system measures the amount of water that passes through the filter and alerts you when it is time to replace Application Guidelines/Water Supply Parameters the filter. To learn how to check the water filter status, see "Using Water Supply the Controls" or "Water Filtration System" in the User Instructions Potable City or Well or User Guide. Water Pressure 30 psi - 120 psi (207 kPa - � After changing the water filter, flush the water system. See 827 kPa) "Water and Ice Dispensers" or "Water Dispenser" in the User Water Temperature 33°F - 100°F (0.6°C - 37.8°C Instructions or User Guide. � These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory Service Flow Rate 0.70 GPM (2.65 L/min.) @ 60 psi. (413.7 kPa) conditions, actual performance may vary. � Your water filtration system will withstand up to 120 pounds per � For installation, operation and maintenance instructions please square inch (psi) water pressure. If your water supply is higher refer Owner's Manual. than 80 psi, install a pressure reducing valve before installing the water filtration system. Consumer Support 1.800.442.9991 By Whirlpool Corporation 2000 North M63 Benton Harbor, MI 49022 Made in Taiwan. *Class I particle size: >0.5 to 1 um †Based on the use of Cryptosporidium parvum oocysts ††Fibers greater than 10 um in length ®NSF is a registered trademark of NSF International. 29