Whirlpool WRT138FFD Installation Instructions - Page 11
Installing the tubing clips
View all Whirlpool WRT138FFD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installing the tubing clips Refer to the side diagram for the following steps. 1. Remove the seven hex-head screws from the rear access cover, then remove the cover and set it aside. NOTE: If you have a later unit with a metal panel, (see DETAIL A), remove the hex-head screw from the access cover. Discard the cover and its screw. Do not remove the 7 hex-head screws from the larger rear access cover. 2. Peel the backing from the adhesive sides of the tubing clips. Press the clips against the back of the cabinet in the right channel at the approximate locations shown in DETAIL B. Center the clips between the fill tube and the top of the access opening. Alternate fill tube designs ares shown in DETAIL C and DETAIL D (for 11 Cubic Foot Top Freezer Models with Fill Tube and Bracket Fill Tube). If you have a bottom freezer, proceed to page 12. If you have a side-by-side (SXS) or a top freezer unit, proceed to page 13. DETAIL C Alternate fill tube design DETAIL D Fill tube with bracket fill tube (11 Cubic Foot Top Freezer Models) Fill Tube Bracket Fill Tube Fill tube for top and SXS freezers only Fill tube for bottom freezer models Remove 7 hexhead screws from rear access cover Right channel DETAIL B Tubing clip Top and SXS freezers Tubing clip Bottom freezers Metal panel Access cover Remove hexhead screw from rear access cover DETAIL A Installing the tubing clips 11