Whirlpool WRT138FFD Installation Instructions - Page 8
Installing the long fill tube extension, Replacing the ice maker wiring cover
View all Whirlpool WRT138FFD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Refer to the side diagram for the following step. You will be working inside the freezer compartment. 1. Install the plastic extension by sliding it over the fill tube as far as it will go. Refer back to the side diagram for the following step. 2. Position the wiring harness so that it is through the slot in the wiring cover. Insert the tab at the back of the wiring cover into the freezer liner slot. Press the pin on the side of the wiring cover into the hole in the side of the freezer liner so it locks into place. Secure the wiring cover with the phillips screw you removed earlier. Proceed to "Installing the tubing clips" on page 11. Slot Wiring harness Long fill tube extension Fill tube Installing the long fill tube extension Insert pin into hole Pin Hole Wiring harness Wiring cover Hole cover Slot Phillips screw Tab Insert tab into slot Break off and discard Replacing the ice maker wiring cover 8