Whirlpool WRT138FFD Installation Instructions - Page 13

Mounting the water valve Refer to the diagram below for the following steps. NOTE: For 11 Cubic Foot Top Freezer Models only, use a wire tie to get together capillary tube and dryer. This should be done by installer before installing water valve, to make more room for water valve installation. Installer should move all thin tubing to be in parallel with cabinet (refrigerator side wall). By doing this, we assure that no copper tubing is above valve connector (see DETAIL A). 1. Locate the 2-pin water valve solenoid connector (with the brown and two white wires) that is tape to the main wiring harness at the lower right corner of the rear access (see DETAIL B). 2. Refer to DETAIL C and insert the 2-pin connector over the water valve solenoid terminals as far as possible (if the harness is not long enough, break the tape holding it to the main harness). You can position the connector with the wires at either terminal. 3. Refer to DETAIL C and mount the water valve to the mounting holes in the cabinet frame with two 1⁄2" hex-head machine screws. Make sure that you tighten these two screws securely. DETAIL A Wire Tie Valve connector Dryer Brown (2) White DETAIL B 2-pin connector DETAIL C Mounting the water valve 2-pin connector Water valve 1⁄2" hex-head machine screws 13