Xerox 1235/DX Troubleshooting Guide - Page 104
Message, Explanation/Corrective Action, Top Output Bin Full Remove
UPC - 042215474542
View all Xerox 1235/DX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Troubleshooting Front Panel Messages (cont'd.) Message Supply Fan Error U9 Power Off/On Temp Sensor Error T29 Power Off/On Toner Empty [Black Toner Empty] [Cyan Toner Empty] [Magenta Toner Empty] [Yellow Toner Empty] Replace Toner Toner Low Black Toner Low Cyan Toner Low Magenta Toner Low Yellow Toner Low Toner Missing [Black Toner Missing [Cyan Toner Missing [Magenta Toner Missing [Yellow Toner Missing Reseat Toner Top Cover A Open Close Top Cover A Top Output Bin Full Remove Prints Transfer Belt Missing Reseat Belt Type Fault Fault Fault Explanation/Corrective Action An error has been detected with the power supply cooling fan. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. The temperature sensor is either not communicating or reporting invalid data. Turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. The toner cartridge has reached its end of life. Install a new toner cartridge. Attention Fault Fault Fault Fault The level of toner in the toner cartridge is low and should be replaced soon, as it is near its end of life. Printing can continue until the toner cartridge is empty; however, some degradation of image quality may occur. The message remains until interrupted by other messages or until the toner cartridge is replaced. The toner is either missing or requires reseating to be recognized by the printer. Reseat the toner. If that does not fix the problem, turn off the printer, wait 15 seconds, then turn on the printer. If the problem persists, check the support links at www.xerox.com/officeprinting/1235support. The top cover (Cover A) is open. Close the cover so that printing can continue. The top (face-down) bin is full and cannot accept any more prints until it is emptied. Once emptied, printing will continue where it left off. The transfer belt is either missing or requires reseating to be recognized by the printer. Turn off the printer, make sure the transfer belt is properly installed and turn on the printer. If the problem persists, install a new transfer belt. For further assistance, visit the support links at www.xerox.com/officeprinting/1235support. 88 Phaser 1235 Network Color Printers