Yamaha AV-S70 Owner's Manual - Page 27

PREPARATION OPERATION OPERATING OTHER COMPONENTS USING THE REMOTE CONTROL 7 Press the remote control selector button you pressed in step 2. Transmission 6 indicator 7 The indicator will go out. 6 Point the remote control at the component to be controlled (the component turned on in step 1) and press p repeatedly until the component's power turns off. If the transmission indicator flashes twice, this indicates that you have cycled through all the codes stored in the memory of the remote control. Up to 300 manufacturer codes (for TV) may be stored in the memory of the remote control. Since a manufacturer code is set by pressing p and cycling in order through these codes, you may need to press p up to 300 times to reach the proper code. y Up to 120 manufacturer codes for VCR, 170 for satellite tuner and 20 for cable TV may be stored in the memory of the remote control. Note • If you accidentally press p too many times after the power is turned off, you may press m the same number of times to go through the manufacturer codes in reverse order. The correct manufacturer code will not be set unless you do this. The transmission indicator will go out once auto preset has been performed properly. Note • During step 6, if you press p about 300 times and the transmission indicator flashes twice slowly and the component's power still has not turned off, this indicates that auto preset cannot be performed for the component in question. Check that the component to be controlled supports remote control operation. You may also try performing manual preset. s Precautions when performing preset The transmission indicator will go out once the manufacturer code has been set properly. If the transmission indicator does not go out, or if it flashes and then goes out, repeat the procedure from step 1. Pay attention to the following points when you repeat the preset procedure. • Check the manufacturer code number. • Check that the correct remote control selector button has been selected when setting the manufacturer code. • If more than one code is given for a manufacturer, try entering each code in the order given. • Remove and replace the remote control's batteries (complete this step within 2 minutes) and then repeat the procedure. s To clear a manufacturer code Perform the procedure "Using manual preset" described on page 23 and enter the following codes when you reach step 3. • To clear the "TV" button: 0000 • To clear the "VCR" button: 0000 • To clear the "SAT" button: 0000 • To clear all buttons for "TV", "VCR" and "SAT": 9990 REMOTE CONTROL APPENDIX English 25