Yamaha DM2000 Owner's Manual - Page 82

68 Chapter 7-Input Channels 7 Input Channels Patching Input Channels AD Inputs, Slot Inputs, internal effects processor outputs, Digital or Analog 2TR Inputs, Bus Outs, or Aux Sends can be patched to the Input Channel Inputs. See "Patching Input Channels" on page 61 for more information. Metering Input Channels Input Channel signal levels can be metered on the Meter pages. See "Metering" on page 103 for more information. Reversing the Signal Phase The signal phase of each Input Channel can be reversed as follows. Using the SELECTED CHANNEL PHASE/INSERT [ ] Button 1 Use the LAYER buttons to select Input Channel Layers, and use the [SEL] buttons to select Input Channels. 2 Use the Phase [ ] button to set the phase. Phase is reversed when the Phase [ ] button indicator is lit. Phase Pages Phase settings can be viewed and set on the Phase pages. If the Auto PHASE/INSERT Display preference is on, these pages appear automatically when the Phase [ ] button in the SELECTED CHANNEL PHASE/INSERT section is pressed. See "Auto PHASE/INSERT Display" on page 234. 1 Use the SELECTED CHANNEL PHASE/INSERT [DISPLAY] button to select the Phase pages. The Phase parameters for the 96 Input Channels are divided between two pages. The Input Channel 1-48 Phase page is shown below. The layout of the other page is the same. 2 Use the cursor buttons or Parameter wheel to select the NOR/REV buttons, and the [ENTER] button and INC/DEC buttons to set them. The NOR/REV buttons can also be selected by using the Input Channel Layer buttons and [SEL] buttons. GLOBAL NOR/REV: These buttons allow you to set the phase of all Input Channels simultaneously. DM2000-Owner's Manual