Yamaha HTR-5440 Owner's Manual - Page 21

INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION Main speakers A Main speakers B CONNECTIONS Right Left Right R+ A SPEAKERS - - +L MAIN B CENTER REAR R (SURROUND) L + - IMPEDANCE SELECTOR SET BEFORE POWER ON MAIN A OR B: 8 MIN. /SPEAKER A + B:16 MIN. /SPEAKER CENTER : 8 MIN. /SPEAKER REAR : 8 MIN. /SPEAKER MAIN A OR B: 4 MIN. /SPEAKER A + B: 8 MIN. /SPEAKER CENTER : 6 MIN. /SPEAKER REAR : 6 MIN. /SPEAKER SUB WOOFER OUTPUT AC OUTLETS SWITCHED 100W MAX. TOTAL Left (HTR-5450/U.S.A. model) Subwoofer system Center speaker Right Left Rear speakers I Subwoofer connection When using a subwoofer with built-in amplifier, including the YAMAHA Active Servo Processing Subwoofer System, connect the input jack of the subwoofer system to this jack. Low bass signals distributed from the main, center and/or rear channels are directed to this jack. (The cut-off frequency of this jack is 90 Hz.) The LFE (low-frequency effect) signals generated when Dolby Digital or DTS is decoded are also directed if they are assigned to this jack. Notes • Adjust the subwoofer volume according to the operation instructions for the subwoofer. (Fine adjustment is possible using this unit's output level control of the effect speakers.) • Depending on the settings of "1 SPEAKER SET", "LFE LEVEL (5 DOLBY D. SET)" and "6 DTS SET" in the SET MENU, some signals may not be output from the SUBWOOFER jack. APPENDIX English 17