Yamaha HTR-5440 Owner's Manual - Page 35

INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION RECORDING A SOURCE Recording adjustments and other operations are performed from the recording component. Refer to the instructions for these components. 1,4 STANDBY /ON D I G I TA L SURROUND BASS TREBLE BALANCE -+ -+ L R SPEAKERS A B ON OFF (HTR-5450) D I G I TA L VOLUME PROGRAM EFFECT PRESET/TUNING PHONES S VIDEO VIDEO L AUDIO R OPTICAL A/B/C/D/E PRESET /TUNING FM/AM EDIT MEMORY TUNING MODE MAN'L/AUTO FM AUTO/MAN'L MONO INPUT MODE INPUT 6CH INPUT SILENT VIDEO AUX 2 4 2 1 Set the volume at the VOLUME minimum level. Front panel 2 Select the source you want to record. INPUT or Front panel Remote control 3 Begin recording by the recording component connected to this unit. 4 Play the source and then turn up the volume to confirm the input source. VOLUME Notes • Do a test recording before you start an actual recording. • When this unit is set in the standby mode, you cannot record between other components connected to this unit. • The DSP program and the setting of VOLUME, BASS, TREBLE and BALANCE have no effect on the material being recorded. • A source connected to the 6CH INPUT jacks of this unit cannot be recorded. • A given input source is not output on the same REC OUT channel. (For example, the signal input from VCR 1 IN is not output on VCR 1 OUT.) • Check the copyright laws in your country to record from records, CDs, radio, etc. Recording of copyrighted material may infringe copyright laws. • HTR-5450 only Composite video and S video signals pass independently through this unit's video circuits. Therefore, when recording or dubbing video signals, if your video source component is connected to provide only an S video (or only a composite video) signal, you can record only and an S video (or only a composite video) signal by your VCR. If you play back a video source that uses scrambled or encoded signals to prevent it from being dubbed, the picture itself may be disturbed due to those signals. I Special considerations when recording DTS software HTR-5450 only The DTS signal is a digital bitstream. Attempting to digitally record the DTS bitstream will result in noise being recorded. Therefore, if you want to use this unit to record sources that have DTS signals recorded on them, the following considerations and adjustments need to be made. For DVDs and CDs encoded with DTS Only 2-channel analog audio signals may be recorded. Set the DVD player (or CD player) as described in the player's operation instructions so that the audio signals are output from the player's analog outputs. or Front panel Remote control APPENDIX English 31