Yamaha NX-N500 NX-N500 Owners Manual - Page 33

Displaying/changing settings Settings for the following parameters can be displayed or changed. ■ Network Name Edits the unit's name that appears on the network. Network Name APPLY Enter the unit's name that will appear on the network. If this unit has been registered with the MusicCast CONTROLLER, the room name entered during registration appears. Click to apply the new name. ■ Network Setup Specifies the network settings. • Some of the following parameters may not appear (or their settings cannot be changed), depending on the selected network connection method. Connection Displays the currently specified network connection Info method. MusicCast Network Displays the MusicCast network status. If "Ready" appears, the MusicCast CONTROLLER can be used. Connection Select the network connection method (Wired LAN/ Select Wireless LAN/Wireless Direct/MusicCast Wireless). With Wireless LAN WPS PIN Displays the WPS PIN code. SSID Enter the SSID for the wireless router (access point). With Wireless LAN/ Wireless Direct Security Security Key Select the security method when connecting with a wireless router (access point) or Wireless Direct. Enter the security key when connecting with a wireless router (access point) or Wireless Direct. DHCP Switches on/off the DHCP function. When turned off, some settings, such as the IP address and subnet mask, can be specified manually. IP Address Displays the IP address for this unit. Subnet Mask Displays the subnet mask for this unit. Default Gateway Displays the default gateway for this unit. DNS Server Displays the address of the primary DNS server. (P) DNS Server Displays the address of the secondary DNS server. (S) APPLY Click to apply the currently specified settings. When connecting with a wireless router (access point) using a WPS PIN code, follow the procedure below to specify the settings. 1 Set "Connection Select" to "Wireless LAN", and then click "APPLY". 2 Select the "WPS PIN" check box, and then click "APPLY". The PIN code appears at the message window. 3 Enter the PIN code for the unit into the wireless router (access point). ■ AirPlay Password Specifies the password for AirPlay playback. Mode Password APPLY Switches on/off the password function. When turned on, a password can be specified. Enter the password to be specified. Click to apply the specified settings. ■ Firmware Update Updates the firmware of this unit. Current Firmware Version Displays the version of the current firmware. START Starts firmware updating. Perform the update operation according to the on-screen instructions. ■ Standby Switches network standby setting. Network Standby Switches network standby setting (On/Off/Auto). For details on the settings, see "Network standby" (p.11). ■ MAC Filter Sets the MAC addresses to limit the network devices that can access the unit. Off On APPLY MAC Address 1-10 Disables the MAC address filter. Enables the MAC address filter. Only the network devices with the MAC addresses specified in "MAC Address 1" to "MAC Address 10" will be able to access the unit. Click to apply the specified settings. Specify the MAC addresses of network devices (up to 10) that can access the unit. • If the MAC address filter is enabled, be sure to specify the MAC address of the PC used for setup. If "APPLY" is clicked without the address specified, this unit will be inaccessible. If this unit becomes inaccessible, reset its network settings (p.32). CONFIGURATIONS 30 En