Yamaha ProR3 ProR3 Owners Manual - Page 6

2 Front panel Front panel 1 23 4 5 6 7 89 L R CLIP -3 -6 -9 -12 -18 -24 -36 INPUT PROGRAM DIGITAL REVERBERATOR STEREO L R MONO PRESET USER MIDI PRE EFFECT EQ 0 FREQ GAIN FREQ GAIN FREQ GAIN ON 100 300 800 2k 4k 10k -00 +10 LR 50 700 -15 +15 LOW 350 5k -15 +15 MID 2k 20k -15 +15 HIGH 0 A DATA/CURSOR INC DEC PARAMETER MAIN FINE EQ EQ ON 7 8 9 PROGRAM INFINITE POWER 4 5 6 STORE GATE GATE ON 1 2 3 CANCEL UTILITY ON/ OFF COMPARE LEVEL/ BAL OTHERS 0 • - RECALL/ ENTER BYPASS B CD 1 INPUT level meters (L/R) This is a stereo LED meter with 8 segments for each channel. The segments respectively indicate levels of -36 dB, -24 dB, -18 dB, -12 dB, -9 dB, -6 dB, -3 dB, and CLIP. Note: The level meters are located in the circuitry after the A/D converter. This means that the CLIP indicator will indicate clipping of the digital signal. Adjust the input level so that the CLIP indicator does not light. 2 PROGRAM number display This is a two-digit seven-segment display that indicates the currently selected program number. If this display is blinking, a new program has been selected but its contents have not yet been recalled. 3 Status indicators These are six LEDs which indicate program status and other functions of the ProR3. STEREO, L/R MONO The input mode of the currently selected program is shown by three indicators. The ProR3 has four input modes (Stereo, LR/Mix, R-Mono, L-Mono), selected by the UTILITY key. When both L/R Mono indicators are lit, LR/Mix mode is selected. PRESET/USER These indicators show the program status. Use the PROGRAM key to select the status. When the PRESET indicator is lit, preset programs are selected. When the USER indicator is lit, user programs are selected. MIDI This indicator will light while MIDI data is being received from an external device connected to the MIDI IN connector. 4 LCD This backlit LCD shows the name of the selected program and the program parameter values. Messages related to operation will also appear here. ProR3 Digital Reverberator