Yamaha SY35 Owner's Manual (getting Started) - Page 28

VV>LEVEL SPEED, Vector Rate 30ms

Get Yamaha SY35 PDF manuals and user guides View all Yamaha SY35 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

3 Turn Vector Play ON Now press the VECTOR PLAY [ON/OFF] key to turn the VECTOR PLAY mode ON, and select [LEVEL] control. Since Vector Play is ON, the dynamic vector will not play. Set the VECTOR CONTROL to center position and play another note or chord. You should hear all 4 elements at the same time, in approximately equal proportions. Play with the VECTOR CONTROL a bit to get a feel for this particular combination of elements. VECTOR CONTROL A A D C D C Recording An Original Dynamic Vector B B Now we'll go ahead and record an original dynamic level vector for the SP* Bell voice. 1 Select the VOICE VECTOR Edit Mode The first step is to enter the VOICE VECTOR edit mode, which we do by pressing the [EDIT/UTILITY] key and then the [VOICE VECTOR] key. 2 Select the LEVEL SPEED Function If the LEVEL SPEED function does not appear immediately when you enter the VOICE VECTOR edit mode, press the [VOICE VECTOR] key a few times until it does appear (Feature Reference manual, page 11). VV>LEVEL SPEED Vector Rate 30ms 25

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
3
Turn Vector Play ON
Now press the VECTOR PLAY [ON/OFF] key to turn the VECTOR PLAY
mode ON, and select [LEVEL] control.
Since Vector Play is ON, the dynamic vector will not play. Set the
VECTOR CONTROL to center position and play another note or chord.
You should hear all 4 elements at the same time, in approximately equal
proportions. Play with the VECTOR CONTROL a bit to get a feel for this
particular combination of elements.
A
B
C
D
VECTOR CONTROL
A
B
C
D
Recording An Original
Dynamic Vector
Now we’ll go ahead and record an original dynamic level vector for the
SP
*
Bell voice.
1
Select the VOICE VECTOR Edit Mode
The first step is to enter the VOICE VECTOR edit mode, which we do by
pressing the [EDIT/UTILITY] key and then the [VOICE VECTOR] key.
2
Select the LEVEL SPEED Function
If the LEVEL SPEED function does not appear immediately when you
enter the VOICE VECTOR edit mode, press the [VOICE VECTOR] key a
few times until it does appear (Feature Reference manual, page 11).
VV>LEVEL SPEED
Vector Rate 30ms