Yamaha YSP 3000 Owner's Manual - Page 108

Troubleshooting ■ Remote control Problem Cause Remedy The remote control does not work and/or function properly. Wrong distance or angle. The remote control functions within a maximum range of 6 m (20 ft) and no more than 45 degrees off-axis from the front panel. Direct sunlight or lighting (from an inverter Reposition this unit. type of fluorescent lamp, etc.) is striking the remote control sensor of this unit. The batteries are weak. Replace all batteries. Cannot operate external components with the remote control of this unit. The external component you want to operate is not selected as the input source. Press INPUT on the front panel or the input selector buttons on the remote control to select the external component you want to operate. The remote control code was not correctly set. Set the remote control code correctly or try another code for the same manufacturer using the "List of remote control codes" at the end of this manual. Even if the remote control code is correctly set, there are some models that do not respond to the remote control. Use the remote control supplied with the external component. The cursor buttons do not work during SET MENU operation. The operation mode selector was unwantedly set to TV/AV. Set the operation mode selector to YSP. Cannot use the My Beam auto-adjust function. Wrong distance or angle. The remote control functions within a maximum range of 6 m (20 ft) and no more than 45 degrees off-axis from the front panel. ■ HDMI Error message Device Error HDCP Error ■ FM tuner Cause The number of the connected HDMI components exceeds the limit. HDCP authentication failed. Remedy Reduce the number of the connected HDMI components. Check that the connected HDMI components support the HDCP copy protection standards. Problem Cause Remedy FM stereo reception is noisy. The characteristics of FM stereo broadcasts may cause this problem when the transmitter is too far away or the antenna input is poor. Check the antenna connections. Try using a high-quality directional FM antenna. Use the manual tuning method. There is distortion, and clear reception cannot be obtained even with a good FM antenna. There is multi-path interference. Adjust the antenna position to eliminate multi-path interference. The desired station cannot be tuned into with the automatic tuning method. The signal is too weak. Use a high-quality directional FM antenna. Use the manual tuning method. Previously preset stations This unit has been disconnected for a long can no longer be tuned into. period. Preset the stations again. See page 30 - 30 45 96 - - 30 See page - - See page 29 - 49 - - 49 50 104 En