Yamaha YSP 3000 Owner's Manual - Page 79
Asetting Parameters 2/3, Bbeam Adjustment, Ahorizontal Angle 1/5, Beam Adjustment Beam Adjustment
UPC - 027108928616
View all Yamaha YSP 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
• Select ANGLE TO WALL OR CORNER if this unit is installed in the corner of your listening room. Adjust the width and length of your listening room as well as the distance of the listening position from this unit. Listening position from the unit Room width MANUAL SETUP ■ BEAM ADJUSTMENT (Beam adjustment) Use to manually adjust the various sound beam settings. We recommend that you select 5 Beam as the beam mode before adjusting these parameters (see page 54). Notes • When INSTALLED POSITION is adjusted in MANUAL SETUP (see page 74), the factory default value is automatically set for this parameter except Center in FOCAL LENGTH (see page 76). • Depending on the beam mode settings (see pages 54 and 60), some channel positions may not be available for selection. In this case, "- -" is displayed. When using Stereo plus 3 Beam as the beam mode, set the surround left and right signals to be output from the front left and right channels. Room length Choices for the room width and length: 2.0 m to 12.0 m (6.5 ft to 40.0 ft) Choices for the listening position from this unit: 1.8 m to 9.0 m (6.0 ft to 30.0 ft) Room width and length p p A)SETTING PARAMETERS 2/3 ----- 5.4m --- | [ 5.4m ] | | p [ ]/[ ]:Up/Down [ ]/[ ]:Sel [ENTER]:Return B)BEAM ADJUSTMENT . a)HORIZONTAL ANGLE b)BEAM TRAVEL LENGTH c)FOCAL LENGTH d)TREBLE GAIN [ ]/[ ]:Up/Down [ENTER]:Enter HORIZONTAL ANGLE (Horizontal angle) Use to adjust the horizontal angle of sound beams for each channel. By adjusting the horizontal angle of the sound beams, you can optimize the sound beam paths. A test tone is automatically output. p p p p p p p Listening position from the unit p p A)SETTING PARAMETERS 3/3 \ [ 2.5m ] \ p [ ]/[ ]:Up/Down [ ]/[ ]:Sel [ENTER]:Return ( ) (+) (+) ( ) Choices: L90° to R90° Adjust toward L (left) to move the direction of the output to the left and adjust toward R (right) to move it to the right. Note When you set the INSTALLED POSITION parameter in MANUAL SETUP (see page 74), the parameters newly set for the width and length of your listening room are automatically set as the factory default value. a)HORIZONTAL ANGLE 1/5 5 beam Front L L90 R90 L65deg * 0(deg) p [ ]/[ ]:Up/Down [ ]/[ ]:Sel [ENTER]:Return ADVANCED OPERATION English 75 En