ZyXEL ES-4124 User Guide - Page 297
Table 120
View all ZyXEL ES-4124 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 297 highlights
Figure 177 Management > Access Control > SNMP Chapter 36 Access Control The following table describes the labels in this screen. Table 120 Management > Access Control > SNMP LABEL DESCRIPTION General Setting Use this section to specify the SNMP version and community (password) values. Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or both (v3v2c). Get Community Set Community Trap Community Trap Destination Version IP Port Note: SNMP version 2c is backwards compatible with SNMP version 1. Enter the Get Community string, which is the password for the incoming Get- and GetNext- requests from the management station. The Get Community string is only used by SNMP managers using SNMP version 2c or lower. Enter the Set Community, which is the password for incoming Set- requests from the management station. The Set Community string is only used by SNMP managers using SNMP version 2c or lower. Enter the Trap Community string, which is the password sent with each trap to the SNMP manager. The Trap Community string is only used by SNMP managers using SNMP version 2c or lower. Use this section to configure where to send SNMP traps from the Switch. Specify the version of the SNMP trap messages. Enter the IP addresses of up to four managers to send your SNMP traps to. Enter the port number upon which the manager listens for SNMP traps. ES-4124 User's Guide 297