2008 BMW X6 Owner's Manual - Page 115
2008 BMW X6 Manual
Page 115 highlights
The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. You can operate the device when the engine is running or when the ignition is switched on. If the device cannot be used after repeated programming, check whether the original hand-held transmitter uses an alternating-code system. To do so, either read the instructions for the original hand-held transmitter or hold down the programmed memory button 1 of the integrated universal remote control. If the LED 2 on the integrated universal remote control flashes rapidly for a short time and then remains lit for approx. 2 seconds, this indicates that the original hand-held transmitter uses an alternating-code system. In the case of an alternating-code system, program the memory buttons 1 as described at Alternating-code hand-held transmitters.< The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. Should you have questions, please contact your BMW Sports Activity Vehicle Center.< Press the left and right-hand memory button 1 for approx. 20 seconds until the LED 2 flashes quickly: All stored programs are deleted. Reassigning individual programs 1. Hold the original hand-held transmitter at a distance of approx. 4 in/10 cm to 12 in/ 30 cm from the memory buttons 1. The required distance between the hand-held transmitter and the memory buttons 1 depends on the relevant system of the original hand-held transmitter used.< 2. Press the desired memory button 1 of the integrated universal remote control. 3. When the LED 2 flashes slowly after approx. 20 seconds, press the transmit button of the original hand-held transmitter. Release both buttons as soon as the LED 2 flashes rapidly. If the LED 2 does not flash rapidly after approx. 15 seconds, alter the distance and repeat the step. Alternating-code hand-held transmitters To program the integrated universal remote control, consult the operating instructions for the equipment to be set. You will find information there on the possibilities for synchronization. When programming hand-held transmitters that employ an alternating code, please observe the following supplementary instructions: Programming will be easier with the aid of a second person.< 1. Park your vehicle within the range of the remote-controlled device. 2. Program the integrated universal remote control as described above in the section Fixed-code hand-held transmitters. 3. Locate the button on the receiver of the device to be set, e.g. on the drive unit. 4. Press the button on the receiver of the device to be set. After step 4, you have approx. 30 seconds for step 5. 5. Press the programmed memory button 1 of the integrated universal remote control three times. 113 Online Edition for Part no. 01 41 0 015 021 - © 11/07 BMW AG Reference Mobility Communications Entertainment Navigation Driving tips Controls Deleting all stored programs At a glance