2008 BMW X6 Owner's Manual - Page 83
2008 BMW X6 Manual
Page 83 highlights
Technology for comfort, convenience and safety PDC Park Distance Control* The concept The PDC assists you when you are parking. Acoustic signals and an optical display* alert you to the approach of an object from behind your vehicle. To measure the distance, there are four ultrasonic sensors in each bumper. The range of these sensors is approx. 7 ft/2 m. However, an acoustic warning first sounds for the sensors at the front and at the two rear corners at approx. 24 in/60 cm, and for the center rear sensors at approx. 5 ft/1.50 m. PDC is a parking aid that can indicate objects when they are approached slowly, as is usually the case when parking. Avoid approaching an object at high speed, otherwise the physical circumstances would mean that the system warning was too late.< Automatic deactivation Controls Reference Mobility Communications Entertainment Navigation Driving tips After driving approx. 165 ft/50 m or at over approx. 20 mph/30 km/h, the system is switched off and the LED goes out. You can reactivate the system manually as needed. Signal tones When nearing an object, the position is correspondingly indicated by an interval tone. Thus, an object detected to the left rear of the vehicle will be indicated by a signal tone from the left rear speaker, etc. As the distance between vehicle and object decreases, the intervals between the tones become shorter. If the distance to the nearest object falls to below roughly 1 ft/30 cm, then a continuous tone sounds. An intermittent tone is interrupted after approx. 3 seconds: > if you remain in front of an object that was only detected by one of the corner sensors > if you drive parallel to a wall Automatic activation Whenever the engine is running or the ignition is on, each time you move the selector lever into position R, the PDC system is activated after approx. 1 second. Wait this short period before driving off. Adjusting You can adjust the volume of the warning tones if the vehicle is equipped with a single drive, refer to page 80. Manual activation Malfunction The LED in the button flashes and a message appears on the Control Display. PDC is malfunctioning. Have the system checked. To prevent this problem, keep the sensors clean and free of ice or snow in order to ensure that they will continue to operate effectively. Do not spray the sensors with high-pressure cleaners for long periods and maintain a distance of at least 4 in/10 cm to them. Press the button, the LED lights up. Manual deactivation Press the button again; the LED goes out. 81 Online Edition for Part no. 01 41 0 015 021 - © 11/07 BMW AG At a glance