2013 Cadillac Escalade Owner Manual - Page 323

Vehicle Care 2. Wipe the cap and the top of the reservoir clean. 3. Unscrew the cap and wipe the dipstick with a clean rag. 4. Replace the cap and completely tighten it. 5. Remove the cap again and look at the fluid level on the dipstick. The level should be between the HOT and COLD marks. If necessary, add only enough fluid to bring the level between the marks. your vehicle in an area where the temperature may fall below freezing, use a fluid that has sufficient protection against freezing. Notice . 10-23 Adding Washer Fluid The WASHER FLUID LOW ADD FLUID message will appear on the Driver Information Center (DIC) when the fluid level is low. See Washer Fluid Messages on page 5‑45. . When using concentrated washer fluid, follow the manufacturer instructions for adding water. Do not mix water with ready-to-use washer fluid. Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system. Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full. Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint. . What to Use To determine what kind of fluid to use, see Recommended Fluids and Lubricants on page 11‑13. Always use the proper fluid. Washer Fluid What to Use When adding windshield washer fluid to the vehicle, be sure to read the manufacturer's instructions before use. If you will be operating Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview on page 10‑5 for reservoir location. .