2013 Cadillac Escalade Owner Manual - Page 326

10-26 Notice . Vehicle Care replacement number shown on the original battery label when a new battery is needed. 2. Leave the ignition on for at least three minutes so that the electronic throttle control will cycle and relearn its home position. 3. Turn the ignition off. 4. Start and run the engine for at least 30 seconds. Using the wrong fluid can badly damage brake hydraulic system parts. For example, just a few drops of mineral-based oil, such as engine oil, in the brake hydraulic system can damage brake hydraulic system parts so badly that they will have to be replaced. Do not let someone put in the wrong kind of fluid. If brake fluid is spilled on the vehicle's painted surfaces, the paint finish can be damaged. Be careful not to spill brake fluid on the vehicle. If you do, wash it off immediately. { WARNING Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling. After a power loss, such as disconnecting the battery or removing the maxi fuses in the power distribution fuse block, the following steps must be performed to calibrate the electronic throttle control. If this is not done, the engine will not run properly. 1. Turn the ignition on but do not start the engine. Vehicle Storage { WARNING Batteries have acid that can burn you and gas that can explode. You can be badly hurt if you are not careful. See Jump Starting on page 10‑99 for tips on working around a battery without getting hurt. Infrequent Usage: Remove the black, negative (−) cable from the battery to keep the battery from running down. . Battery The battery is in the trunk, behind the trim panel, on the passenger side of the vehicle. Refer to the