2012 Chevrolet Avalanche Owner's Manual - Page 185

Lighting When the hazard warning flashers are on, the vehicle's turn signals will not work. signal lever for more than one second causes the turn signals to flash until the lever is released. The lever returns to its starting position when it is released. If after signaling a turn or a lane change the arrows flash rapidly or do not come on, a signal bulb may be burned out. Have the bulbs replaced. If the bulb is not burned out, check the fuse. See Instrument Panel Fuse Block on page 10‑42 and Engine Compartment Fuse Block on page 10‑38. Turn Signal On Chime If the turn signal is left on for more than 1.2 km (0.75 mi), a chime sounds at each flash of the turn signal and the message TURN SIGNAL ON also appears in the DIC. See Lamp Messages on page 5‑37. To turn the chime and message off, move the turn signal lever to the off position. 6-5 Fog Lamps If your vehicle has fog lamps you can use them for better vision in foggy or misty conditions. Your parking lamps and/or low-beam headlamps must be on for your fog lamps to work. Turn and Lane-Change Signals An arrow on the instrument panel cluster flashes in the direction of the turn or lane change. Move the turn signal lever all the way up or down to signal a turn. Raise or lower the lever until the arrow starts to flash to signal a lane change. The turn signals automatically flash three times. It will flash six times if the tow-haul mode is active. Holding the turn The fog lamp button is located on the left side of your instrument panel. # (Fog Lamps): Press the button to turn the fog lamps on. An indicator light will glow near the button when the fog lamps are on. Press the button again to turn them off.