2012 Chevrolet Colorado Owner's Manual - Page 100

3-52 Seats and Restraints Right Front Seat - Regular/ Extended Cab without Rear Seats The vehicle has a right front passenger airbag and may also have a passenger sensing system. If the vehicle has a passenger sensing system it is designed to turn off the right front passenger frontal airbag when an infant in a rear-facing infant seat or a small child in a forward-facing child restraint or booster seat is detected. See "Securing Child Restraints (Right Front Seat Position)" later in this section and Passenger Sensing System on page 3‑27 for important safety information and additional information on installing a child restraint in the right front seat position. 1. See "Securing Child Restraints (Right Front Seat Position)" later in this section for instructions on installing the child restraint using the safety belts. 2. If the child restraint manufacturer's instructions recommend that the top tether be attached, attach and tighten the top tether to the top tether anchor. Refer to the child restraint instructions and the following steps: 2.1. Pull the seatback forward to access the top tether anchor. See Seatback Latches on page 3‑6. 2.2. Pull on the finger access tab to remove the cover to access the top tether anchor. 2.2. Route the top tether (A) through the loop (B) at the top of the seatback to attach the top tether to the nearest top tether anchor (C). 3. Tighten the lower anchor attachments and the top tether. The child restraint instructions will show you how. 4. Before placing a child in the child restraint, make sure it is securely held in place. To check, grasp the child restraint at the LATCH path and attempt to move it side to side and back and forth. There should be no more than 2.5 cm (1 in) of movement for proper installation.