2012 Chevrolet Colorado Owner's Manual - Page 176

7-28 Infotainment System To Transfer Audio From the Bluetooth System to a Cell Phone Ending a Call To end a call: 1. Press and release 2. Say "End Call." Voice Pass-Thru Voice Pass‐Thru allows access to the voice recognition commands on the cell phone. See the cell phone manufacturer's user guide to see if the cell phone supports this feature. This feature can be used to verbally access contacts stored in the cell phone. 1. Press and release g. During a call with the audio in the vehicle: 1. Press and release g. Muting a Call During a call, all sounds from inside the vehicle can be muted so that the person on the other end of the call cannot hear them. To mute a call, press say "Mute Call." 2. Say "Transfer Call." To Transfer Audio to the Bluetooth System From a Cell Phone During a call with the audio on the cell phone, press g for more than two seconds. The audio transfers to the vehicle. If the audio does not transfer to the vehicle, use the audio transfer feature on the cell phone. See your cell phone manufacturer's user guide for more information. g. g , and then g , and then 2. Say "Bluetooth." This command can be skipped. 3. Say "Voice." . To cancel mute, press say "Un‐mute Call." Transferring a Call Audio can be transferred between the Bluetooth system and the cell phone. The cell phone must be paired and connected with the Bluetooth system before a call can be transferred. The connection process can take up to two minutes after the ignition is turned to ON/RUN. The cell phone's normal prompt messages will go through its cycle according to the phone's operating instructions.