2012 Chevrolet Colorado Owner's Manual - Page 40

2-12 Keys, Doors, and Windows 3. After the engine has started, turn the key to LOCK/OFF, and remove the key. 4. Insert the second current driver's key in the ignition and start the engine within ten seconds of removing the previous key. If the engine does not start see your dealer for service. 5. After the engine has started, turn the key to LOCK/OFF, and remove the key. Insert the key to be programmed and turn it to ON/RUN within ten seconds of removing the previous key. The security light turns off once the key has been programmed. 6. Repeat Steps 1 through 5 if additional keys are to be programmed. If the security light comes on and stays on while driving, the engine will restart if you turn it off. However, the theft-deterrent system is not working properly and must be serviced by your dealer. The vehicle is not protected by the theft-deterrent system at this time. In an emergency, contact Roadside Assistance. See Roadside Assistance Program (U.S. and Canada) on page 13‑8 or Roadside Assistance Program (Mexico) on page 13‑10. Do not leave the key or device that disarms or deactivates the theft deterrent system in the vehicle. It is possible for the theft-deterrent system decoder to learn the transponder value of a new or replacement key. Up to 10 keys can be programmed for the vehicle. The following procedure is for programming additional keys only. Canadian Owners: If the keys are lost or damaged, only a dealer can service the theft-deterrent system to have new ones made. Two current driver's keys are required to program additional keys. To program a new key: 1. Verify that the new key has PK3+ stamped on it. 2. Insert the current driver's key in the ignition and start the engine. If the engine does not start see your dealer for service.