2013 Chevrolet Equinox Owner Manual - Page 228

9-34 Driving and Operating flash on the instrument panel. This also occurs when traction control or TSC is activated. A noise may be heard or vibration may be felt in the brake pedal. This is normal. Continue to steer the vehicle in the intended direction. If there is a problem detected with StabiliTrak, SERVICE STABILITRAK is displayed on the Driver Information Center (DIC) and d will stay on. See Ride Control System Messages on page 5‑29. When this message is displayed and/or d comes on and stays on, the vehicle is safe to drive but the system is not operational. Driving should be adjusted accordingly. If d comes on and stays on, reset the system by: 1. Stopping the vehicle. 2. Turning the engine off and waiting 15 seconds. 3. Starting the engine. If d still comes on and stays on at a speed above 20 km/h (13 mph), see your dealer for service. applies braking pressure to the vehicle's brakes to help steer the vehicle in the intended direction. StabiliTrak is on automatically whenever the vehicle is started. To assist with directional control of the vehicle, the system should always be left on. Trailer Sway Control (TSC) is also on automatically when the vehicle is started. See Trailer Sway Control (TSC) on page 9‑57. When the stability control system activates, the Traction Control System (TCS)/StabiliTrak light will g is on the console. Both StabiliTrak and Traction Control can be turned off if needed by pressing and holding g until g and i come on in the instrument cluster.