2013 Chevrolet Equinox Owner Manual - Page 41
2013 Chevrolet Equinox Manual
Page 41 highlights
Keys, Doors, and Windows Do not force the liftgate open or closed during a power cycle. The power liftgate may be temporarily disabled under extreme temperatures or low battery conditions. If this occurs, the liftgate can still be operated manually. If the vehicle is shifted out of P (Park) while the power function is in progress, the liftgate power function will continue to completion. If the vehicle is shifted out of P (Park) and accelerated before the power liftgate latch is closed, the liftgate may reverse to the open position. Cargo could fall out of the vehicle. Always make sure the power liftgate is closed and latched before driving away. If the liftgate is power opened and the liftgate support struts have lost pressure, the turn signals flash and a chime will sound. The liftgate stays open temporarily, and then slowly closes. See a dealer for service before using the liftgate. 2-11 Obstacle Detection Features If the liftgate encounters an obstacle during a power open or close cycle, a warning chime will sound and the liftgate will automatically reverse direction to the full closed or open position. After removing the obstruction, the power liftgate operation can be used again. If the liftgate encounters multiple obstacles on the same power cycle, the power function will deactivate and a message will display in the Driver Information Center (DIC), see Object Detection System Messages on page 5‑29. After removing the obstructions, the liftgate will resume normal power operation. Pinch sensors are located on the side edges of the liftgate. If an object is caught between the liftgate and the vehicle and presses against this sensor, the liftgate will reverse direction and open fully. The liftgate will remain open until it is activated again or closed manually. Power Liftgate 3/4 Mode To program the liftgate opening height: 1. Turn the liftgate switch to either the MAX, or the 3/4 mode position and power open the liftgate. 2. Stop the liftgate movement at the desired height by pressing any liftgate switch. Manually adjust the liftgate position if required. 3. Press and hold the button on the liftgate adjacent to the latch until the turn signals flash and a beep sounds to indicate that the new setting is recorded. When power opened with the 3/4 mode selected, the liftgate stops at the new set position.