2013 Chevrolet Equinox Owner Manual - Page 230

9-36 Driving and Operating SET/− (Set/Coast): Move the thumbwheel down toward SET/- to set a speed and activate cruise control, or to make the vehicle decelerate. Setting Cruise Control If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise button turned off when cruise control is not being used. Once the vehicle reaches about 40 km/h (25 mph) or more, move the thumbwheel up toward RES/+ briefly. The vehicle returns to the previous set speed and stays there. Increasing Speed While Using Cruise Control If the cruise control system is already activated, . ON/OFF 5 CRUISE: Press to turn the cruise control system on and off. 1. Press ON/OFF 5 CRUISE. . 2. Get to the speed desired. 3. Press the thumbwheel and release it. The desired set speed briefly appears in the Driver Information Center (DIC) display. 4. Take your foot off the accelerator pedal. Resuming a Set Speed If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged without erasing the set speed from memory. Move the thumbwheel up toward RES/+ and hold it until the vehicle accelerates to the desired speed, and then release it. To increase the speed in small amounts, move the thumbwheel up toward RES/+ briefly and then release it. Each time this is done, the vehicle goes about 1.6 km/h (1 mph) faster. * CANCEL: Press to disengage cruise control without erasing the set speed from memory. RES/+ (Resume/Accel): Move the thumbwheel up toward RES/+ to make the vehicle resume to a previously set speed or to accelerate. Reducing Speed While Using Cruise Control If the cruise control system is already activated,