2013 Chevrolet Express 1500 Cargo Owner Manual - Page 209
2013 Chevrolet Express 1500 Cargo Manual
Page 209 highlights
Driving and Operating To Use the Engine Coolant Heater 1. Turn off the engine. 2. Open the hood and unwrap the electrical cord. The cord for the engine coolant heater is located on the driver side of the engine compartment and is attached to the hose for the power steering reservoir. 3. Plug it into a normal, grounded 110-volt AC outlet. 9-19 WARNING (CONTINUED) If the cord will not reach, use a heavy-duty three-prong extension cord rated for at least 15 amps. 4. Before starting the engine, be sure to unplug and store the cord as it was before to keep it away from moving engine parts and prevent damage. The length of time the heater should remain plugged in depends on several factors. Ask a dealer in the area where you will be parking the vehicle for the best advice on this. These features will work when the ignition key is in ON/RUN or ACC/ ACCESSORY. Once the key is turned from ON/RUN to LOCK/OFF, power to the radio and power windows will continue to work 10 minutes or until the driver door is opened. Shifting Into Park 1. Hold the brake pedal down, then set the parking brake. 2. Move the shift lever into the P (Park) position by pulling the shift lever toward you and moving it up as far as it will go. 3. Turn the ignition key to LOCK/OFF. 4. Remove the key and take it with you. If you can leave the vehicle with the ignition key in your hand, the vehicle is in P (Park). { WARNING Plugging the cord into an ungrounded outlet could cause an electrical shock. Also, the wrong kind of extension cord could overheat and cause a fire. You could be seriously injured. Plug the cord into a properly grounded three-prong 110-volt AC outlet. (Continued) Retained Accessory Power (RAP) These vehicle accessories can be used for up to 10 minutes after the engine is turned off: . . Audio System Power Windows (if equipped)