2013 Chevrolet Express 1500 Cargo Owner Manual - Page 259

Vehicle Care parts or exhaust system parts, starting a fire. Too little fluid could cause the transmission to overheat. Be sure to get an accurate reading if checking the transmission fluid. Wait at least 30 minutes before checking the transmission fluid level if you have been driving: . 10-11 until the engine temperature gauge moves and then remains steady for 10 minutes. A cold fluid check can be made after the vehicle has been sitting for eight hours or more with the engine off, but this is used only as a reference. Let the engine run at idle for five minutes if outside temperatures are 10°C (50°F) or more. If it is colder than 10°C (50°F), the engine may have to idle longer. Should the fluid level be low during this cold check, the fluid must be checked hot before adding fluid. Checking the fluid hot will give a more accurate reading of the fluid level. Checking the Fluid Level Prepare the vehicle as follows: 1. Park the vehicle on a level place. Keep the engine running. 2. With the parking brake applied, place the shift lever in P (Park). 3. With your foot on the brake pedal, move the shift lever through each gear range, pausing for about three seconds in each range. Then, position the shift lever in P (Park). 4. Let the engine run at idle for three minutes or more. Then, without shutting off the engine, use the steps that follow. When outside temperatures are above 32°C (90°F). At high speed for quite a while. In heavy traffic - especially in hot weather. While pulling a trailer. . . . To get the right reading, the fluid should be at normal operating temperature, which is 82°C to 93°C (180°F to 200°F). Get the vehicle warmed up by driving about 24 km (15 mi) when outside temperatures are above 10°C (50°F). If it is colder than 10°C (50°F), drive the vehicle in 3 (Third) The transmission dipstick is near the center of the engine compartment and will be labeled with the graphic shown. See Engine Compartment Overview on page 10‑6. 1. Flip the handle up, pull out the dipstick, and wipe it with a clean rag or paper towel.