2013 Chevrolet Express 1500 Cargo Owner Manual - Page 225

Driving and Operating +RES (Resume/Accelerate): Press briefly to make the vehicle resume to a previously set speed, or press and hold to accelerate. SET− (Set/Coast): Press to set the speed and activate cruise control or press and hold to decelerate. The cruise control light on the instrument cluster comes on after the cruise control has been set to the desired speed. 1. Press the 9-35 Increasing Speed While Using Cruise Control If the cruise control system is already activated, . I button. 2. Get up to the desired speed. 3. Press the SET− button on the steering wheel and release it. 4. Take your foot off the accelerator. Resuming a Set Speed If the cruise control is set at a desired speed and then the brakes are applied, the cruise control is disengaged without erasing the set speed from memory. Once the vehicle speed reaches about 40 km/h (25 mph) or more, press the +RES button on the steering wheel. The vehicle returns to the previous set speed and stays there. . [ (Cancel): Press to disengage cruise control without erasing the set speed from memory. Setting Cruise Control If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise control switch off when cruise is not being used. Press and hold the +RES button on the steering wheel until the desired speed is reached, then release it. To increase vehicle speed in small amounts, press the +RES button. Each time this is done, the vehicle goes about 1.6 km/h (1 mph) faster. Reducing Speed While Using Cruise Control If the cruise control system is already activated: . Press and hold the SET- button on the steering wheel until the desired lower speed is reached, then release it.