2014 Chevrolet SS Owner Manual - Page 250

9-18 Driving and Operating the accelerator pedal all the way to the floor and holding it there as you press the ENGINE START/STOP button, for up to a maximum of 15 seconds. Wait at least 15 seconds between each try, to allow the cranking motor to cool down. When the engine starts, let go of the button and the accelerator. If the vehicle starts briefly but then stops again, do the same thing. This clears the extra gasoline from the engine. Do not race the engine immediately after starting it. Operate the engine and transmission gently until the oil warms up and lubricates all moving parts. Once the ignition is turned off, RAP allows the power windows to continue to operate for up to 10 minutes. If a door is opened during this time, they will be deactivated. The audio system will be deactivated only if the driver door is opened. pressed for many seconds, cranking will be stopped after 15 seconds to prevent cranking motor damage. To prevent gear damage, this system also prevents cranking if the engine is already running. Engine cranking can be stopped by pressing the ENGINE START/ STOP button a second time. { Caution Cranking the engine for long periods of time, by pressing the ENGINE START/STOP button immediately after cranking has ended, can overheat and damage the cranking motor, and drain the battery. Wait at least 15 seconds between each try, to let the cranking motor cool down. 2. If the engine does not start after five to 10 seconds, especially in very cold weather (below −18°C or 0°F), it could be flooded with too much gasoline. Try pushing Shifting Into Park 1. Hold the brake pedal down and set the parking brake. See Electric Parking Brake on page 9-27. 2. Hold the button on the shift lever and push the lever toward the front of the vehicle into P (Park). 3. Turn the ignition off. Retained Accessory Power (RAP) The power windows will operate when the ignition is in the ON/RUN or ACC/ACCESSORY positions.