2014 Chevrolet SS Owner Manual - Page 341

Vehicle Care 12. Switch the on/off switch (1) to the O position. The tire is not sealed and will continue to leak air until the vehicle is driven and the sealant is distributed in the tire. Therefore, Steps 13-19 must be done immediately after Step 12. Be careful while handling the tire sealant and compressor kit as it could be warm after usage. 13. Unplug the power plug (6) from the accessory power outlet in the vehicle. 14. Turn the sealant/air hose (5) counterclockwise to remove it from the tire valve stem. 15. Replace the tire valve stem cap. 16. Replace the sealant/air hose (5), and the power plug (6 back in their original location. 10-59 20. Stop at a safe location and check the tire pressure. Refer to Steps 1-10 under "Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)." 17. If the flat tire was able to inflate to the recommended inflation pressure, remove the maximum speed label from the tire sealant canister (3) and place it in a highly visible location. Do not exceed the speed on this label until the damaged tire is repaired or replaced. 18. Return the equipment to its original storage location in the vehicle. 19. Immediately drive the vehicle 8 km (5 mi) to distribute the sealant in the tire. If the tire pressure has fallen more than 68 kPa (10 psi) below the recommended inflation pressure, stop driving the vehicle. The tire is too severely damaged and the tire sealant cannot seal the tire. See Roadside Assistance Program on page 13-5. If the tire pressure has not dropped more than 68 kPa (10 psi) from the recommended inflation pressure, inflate the tire to the recommended inflation pressure. 21. Wipe off any sealant from the wheel, tire or vehicle. 22. Dispose of the used tire sealant canister (3) and sealant/air hose (5) assembly