2010 Chrysler Town & Country Owner Manual - Page 352

STARTING AND OPERATING 351 position, then goes out. If the "ESP/BAS Warning Light" comes on continuously with the engine running, a malfunction has been detected in either the ESP or the BAS system. If this light remains on after several ignition cycles, and the vehicle has been driven several miles/ NOTE: To improve the vehicle's traction when driving kilometers at speeds greater than 30 mph (48 km/h), see with snow chains, or starting off in deep snow, sand or your authorized dealer as soon as possible to have the gravel, it may be desirable to switch to the "Partial Off" problem diagnosed and corrected. mode by pressing the "ESP OFF" switch. Once the situation requiring ESP to be switched to the "Partial Off" NOTE: mode is overcome, turn ESP back on by momentarily • The "ESP/TCS Indicator Light" and the "ESP/BAS Warning Light" come on momentarily, each time the pressing the "ESP OFF" switch. This may be done while ignition switch is turned ON. the vehicle is in motion. than ESP would normally allow is required to gain traction. To turn ESP on again, momentarily press the "ESP OFF" switch. This will restore the normal "ESP On" mode of operation. ESP/BAS Warning Light • Each time the ignition is turned ON, the ESP System will be ON, even if it was turned off previously. The malfunction indicator light for the ESP is combined with BAS. The "ESP/BAS Warning • The ESP Control System will make buzzing or clicking Light" and the "ESP/TCS Indicator Light" (in sounds when it is active. This is normal. The sounds the instrument cluster) come on for four secwill stop when ESP becomes inactive, following the onds when the ignition switch is turned to the ON maneuver that caused the ESP activation. 5